-40%
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure
Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure

Noise Source Generator Calibrated (10 -1600 MHz; ~ 15 dB ENR, SMA) Noise Figure

$ 142.03

Availability: 100 in stock
  • MPN: XDM NSE15-2S100
  • All returns accepted: Returns Accepted
  • Bundle Listing: No
  • Brand: XDM-1600
  • Item must be returned within: 30 Days
  • Return shipping will be paid by: Buyer
  • Restocking Fee: 10%
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Type: Noise source
  • Country/Region of Manufacture: United States
  • Condition: New

    Description

    Wide-Band Noise Source (10 - 1600 MHz)
    Frequency (10 - 1600 MHz)
    ~
    15 dB
    ENR (Calibrated ENR values measured at
    72.3°F
    against calibrated Agilent 346B noise source
    )
    Supply voltage (16 - 28 V)
    Operating current ( < 10mA)
    RF OUT (*SMA Female)
    Power Connector ( BNC Female)
    Compatible with HP8970A/B and Ailtech/Eaton noise figure measuring instruments
    Low cost add-on for spectrum analyzers without a tracking generator
    (*May need additional high gain amplifiers)
    One-year conditional warranty
    Used by various universities, research and manufacturing facilities worldwide
    Low cost alternative to HP/Agilent noise sources for noise figure measurements
    Please note picture is of a stock item for illustration only
    . You will receive a similar-looking  item but the frequency vs ENR values on the label may be different.
    *See our other listing if you want an N-type RF connector, or for noise source with integral RF amplifier stages.
    FAQ:
    Why can ’t I see my noise source on a spectrum an analyzer?
    I
    f you are attempting to measure a lower power noise source, < 30 dB ENR, in all probability the
    spectrum analyzer Noise Figure, which usually is at a minimum of 25 dB and many times is 35
    dB, is above the noise level of noise source. At these levels we can approximate Noise Figure
    and ENR and compare directly to see if the noise source will be detectable. This source could be
    measured with an LNA in front of the Spectrum Analyzer"
    . -
    NoiseWave application note
    ---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
    Use Examples
    Since no active links are allowed on eBay as of Sept 15, 2017 please search:
    Google:
    "
    Signal Level Measurement with PowerSDR and External Transverters" by
    Dr. Carol F. Milazzo
    YouTube:
    KF5OBS #34: Noise Figure Measurement (Y Factor Method)
    KF5OBS #33: Filter Measurement using Noise Source